Learn how to check the connections of your Shaw Digital Phone Terminal (DPT) or BlueCurve Gateway. While your Shaw Home Phone Service was installed by one of Shaw’s professional installation technicians, a situation may arise where you will need to verify the connections leading to and from your Shaw Digital Phone Terminal.

How to check your connection

Follow these steps to check the connection of your Shaw Digital Phone Terminal.

  1. Identify which Phone hardware you're using. You'll either have a Digital Phone Terminal (DPT), or a BlueCurve Gateway.
  2. Once you have correctly identified which model is in use, please refer to the diagrams below for a visual explanation of the wiring which will include the power, cable (coaxial) and at least a single (1) phone line.

Visual Guide: Motorola SBV5220

Here is a look at the connections for the Motorola SBV5220 Digital Phone Terminal.




Visual Guide: Arris TM602

Here is a look at the connections for the Arris TM602 Digital Phone Terminal.



Visual Guide: BlueCurve Gateway

Here is a look at the connections for the BlueCurve Gateway.



  1. Connect your coax cable and power cord to your Shaw BlueCurve Gateway.
  2. Connect your coax cable to the cable outlet and plug your power cord into an electrical outlet
  3. If you're a BlueCurve with Phone customer, connect your telephone to the Tel 1 connection on your Gateway using a telephone cord (not included).

Note: For first time Self Connect setup, it is important to follow the separate instructions in the guide included in your Self Connect kit.


Labels (2)
We're Here to Help